Showing posts with label w. Show all posts
Showing posts with label w. Show all posts
Sunday, September 7, 2014
Car Amplifier Circuit 2 x 30 W stereo
This circuit use the IC AN7166 . On circuit have an advantage is very loud sound , although only 30W this circuit is like a 100 W transistor power amplifier. Its so good circuit with IC AN7166 . This circuit require minimum voltage 12 V and Maximum voltage 24 volt , I recomended voltage for this circuit is 18 volt. And use the battery supply current 5 Ampere. Maximum power output of one speaker 30 W with impedance 4 Ohm.
See this circuit schematic below :
Capacitor thats connect legs IC 4 and 3 is 1 nF . And capacitor thats connect legs IC 9 and 3 is 1 nF. For the input capacitor at 1 uF ( L and R ) for output capacitor at 1000uF with voltage 50 V or higher.
Saturday, September 6, 2014
4 x 42 W quad bridge car radio amplifier TDA7385
Features
■ High output power capability:
– 4 x 42 W / 4 max.
– 4 x 23 W / 4 @ 14.4 V, 1 kHz, 10 %
■ Clipping detector
■ Low distortion
■ Low output noise
■ Standby function
■ Mute function
■ Automute at min. supply voltage detection
■ Diagnostics facility for:
– Clipping
– Out to GND short
– Out to VS short
– Thermal shutdown
■ Low external component count:
– Internally fixed gain (26 dB)
– No external compensation
– No bootstrap capacitors
■ Protections:
– Output short circuit to GND, to VS, across
the load
– Very inductive loads
– Overrating chip temperature with soft
thermal limiter
– Load dump voltage
– Fortuitous open GND
Circuit Diagram
■ High output power capability:
– 4 x 42 W / 4 max.
– 4 x 23 W / 4 @ 14.4 V, 1 kHz, 10 %
■ Clipping detector
■ Low distortion
■ Low output noise
■ Standby function
■ Mute function
■ Automute at min. supply voltage detection
■ Diagnostics facility for:
– Clipping
– Out to GND short
– Out to VS short
– Thermal shutdown
■ Low external component count:
– Internally fixed gain (26 dB)
– No external compensation
– No bootstrap capacitors
■ Protections:
– Output short circuit to GND, to VS, across
the load
– Very inductive loads
– Overrating chip temperature with soft
thermal limiter
– Load dump voltage
– Fortuitous open GND
Circuit Diagram
 |
| 4 x 42 W quad bridge car radio amplifier TDA7385 |
Thursday, September 4, 2014
2 X 20 W car amplifier circuit with TDA2009
Minimum Voltage required for this circuit 8 volt and maximum voltage 28 volt . Its can use to amplifier on the electronic devices such us Radio , DVD , MP4 , MP5 , and etc. To amplify the signal sound to audio sound , Maximum output power 2 x 20 Watts with impedance 4 ohm. The circuit is stereo amplifier. You can use the circuit to car amplifier because support to subwoofer speaker. See schematic diagram below :
Subscribe to:
Posts (Atom)